From: Bruce Beattie (bruce@eecs.berkeley.edu)
Date: Thu Jun 27 2002 - 14:07:51 PDT
If all else fails, get the 3 1/2" socket and tack weld some shims inside the
socket.
Drill a hole in the middle of each shim and then weld thru the hole. should be
easier to debur etc. This is just an idea, I've never actually done this.
Bruce MVPA 23824
Spunky's Motor Pool wrote:
> Hi List,
>
> I have a need for a 3/4 drive hex 3 3/8" wheel socket. I've checked with
> Snap-On, Mac Tools, Napa, looked on the web, and I can't find anybody that
> carries one in that size. They all jump from 3 to 3 1/2" I'm working on a
> M105A2 trailer.
>
> Does anyone have one, and if so remember where they got it?
>
> Any leads would be GREATLY appreciated!
>
> Thanks in advance,
>
> Harold
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Fri Aug 16 2002 - 11:23:35 PDT