From: Combat (hellcat@provide.net)
Date: Thu Aug 01 2002 - 15:30:04 PDT
Perhaps I am being misunderstood here guys, I only need a ring and pinion to
dimension NOT a complete center section.
As far as target ratio I am considering several but the idea is to get the
deuces up to a comfortable 60-62 mph (yes I know this will hurt what little
acceleration they do have but.... ) A little off the subject bit isnt the 5
ton a 6:42 ratio?
A question for you guys is how many could be sold? (not trying to get rich
but recoup the tooling costs)
----- Original Message -----
From: <Recovry4x4@aol.com>
To: Military Vehicles Mailing List <mil-veh@mil-veh.org>
Sent: Thursday, August 01, 2002 12:16 PM
Subject: Re: [MV] Deuce info needed...
> I have a spare center section. It would cost a fortune to ship it both
ways
> though. If the R/P mfr manages to make up a new ratio, what is the target
> ratio? I'm in FLA so if one can afford to ship it both ways, I'll loan it
> out! Rikk, if you locate any difflock axles here in the states, let me
know.
> I found the axles used in Norway at $555 each.
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Fri Aug 16 2002 - 11:38:28 PDT