From: Combat (hellcat@provide.net)
Date: Thu Aug 01 2002 - 15:37:54 PDT
Check that the ring pinion & reduction gearsets
----- Original Message -----
From: Combat <hellcat@provide.net>
To: Military Vehicles Mailing List <mil-veh@mil-veh.org>
Sent: Thursday, August 01, 2002 6:30 PM
Subject: Re: [MV] Deuce info needed...
> Perhaps I am being misunderstood here guys, I only need a ring and pinion
to
> dimension NOT a complete center section.
>
> As far as target ratio I am considering several but the idea is to get the
> deuces up to a comfortable 60-62 mph (yes I know this will hurt what
little
> acceleration they do have but.... ) A little off the subject bit isnt the
5
> ton a 6:42 ratio?
>
> A question for you guys is how many could be sold? (not trying to get rich
> but recoup the tooling costs)
>
>
> ----- Original Message -----
> From: <Recovry4x4@aol.com>
> To: Military Vehicles Mailing List <mil-veh@mil-veh.org>
> Sent: Thursday, August 01, 2002 12:16 PM
> Subject: Re: [MV] Deuce info needed...
>
>
> > I have a spare center section. It would cost a fortune to ship it both
> ways
> > though. If the R/P mfr manages to make up a new ratio, what is the
target
> > ratio? I'm in FLA so if one can afford to ship it both ways, I'll loan
it
> > out! Rikk, if you locate any difflock axles here in the states, let me
> know.
> > I found the axles used in Norway at $555 each.
> >
> > ===Mil-Veh is a member-supported mailing list===
> > To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> > To switch to the DIGEST mode, send e-mail to
<mil-veh-digest@mil-veh.org>
> > To reach a human, contact <ack@mil-veh.org>
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Fri Aug 16 2002 - 11:38:28 PDT