From: Joe Shannon (fordpart@bellsouth.net)
Date: Mon Nov 11 2002 - 18:12:04 PST
I have made a square plate out of 1/2 inch steel with a grease fitting
in it and used it the same way over one cylinder but keep in mind this
is 3000 pounds of pressure.
Jon Shoop wrote:
>Have a bud here in St louis that restores really OLD and forgotten tractors.
>Some of these things have been sitting for 50 years..outside.
>
>He pre lubes cylinders with KROYL and finds the top piston and uses a spark
>plug adaptor with a grease fitting on it and pumps the cylinder till it
>breaks loose, then takes over with a breaker bar...
>
>Sounds primitive, but you would not believe the number of engines he gets to
>turn over and get running again.....it simply amazes me.
>
>Jon
>
>
>===Mil-Veh is a member-supported mailing list===
>To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
>To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
>To reach a human, contact <ack@mil-veh.org>
>
>
>
This archive was generated by hypermail 2.1.4 : Wed Apr 23 2003 - 13:37:50 PDT