From: Steve & Jeanne Keith (cckw@attbi.com)
Date: Thu Dec 19 2002 - 08:56:03 PST
There is a gasket set that most of the M151 dealers have. You need to remove
the manifold and engine pipe.
The trickiest part is getting all the gaskets to stay in place AND getting
the bolt that goes
into the block below started. Get that one started 1st!!!
Steve AKA Dr Deuce
----- Original Message -----
From: "Gundocmike" <gundocmike@okplus.com>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Thursday, December 19, 2002 10:29 AM
Subject: [MV] M151A2 Exhaust Manifold leaking
> Howdy, List
> I recently found out my M151A2 has an exhaust leak where the engine meets
the exhaust manifold. Does
> anyone know what parts I will need to fix this? The TM -34P shows a square
looking gasket, but it
> only shows one in the book, shouldn't there be 4 of these?
> Thanks,
> Mike
>
>
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
>
This archive was generated by hypermail 2.1.4 : Wed Apr 23 2003 - 13:24:42 PDT