From: Fred Martin (mung@in-touch.net)
Date: Thu Feb 27 2003 - 15:10:48 PST
If your manifold is flat across the flange surface...I have put many old
tractor manifolds on a belt sander and resurfaced them as good as new.
Takes just a few minutes and a new gasket. Fred Martin
Gundocmike wrote:
> Howdy list,
> Here's one for all the experienced Mutt doctors.
> My exhaust manifold is leaking between the exhaust ports on the head and the exhaust manifold (there
> is black soot there). My manual says to just use graphite grease between the head & exhaust
> manifold, but I see where you can buy 4 small square looking gaskets (exhaust manifold gaskets) on
> the internet. Which is correct and does the best job? Also Rapco Parts had a "leaking exhaust
> manifold kit" for sale for the M151A2 ( saw it in ad in Mil Veh Magazine), does anyone know what
> this kit includes?
> Thanks,
> Mike
>
>
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
>
This archive was generated by hypermail 2.1.4 : Wed Apr 23 2003 - 13:25:35 PDT