From: David Cole (DavidCole@tk7.net)
Date: Mon Apr 14 2003 - 08:00:55 PDT
Joe,
What do you use to lift the engine? A heavy duty engine lift, overhead
crane, wrecker? Also what is the total powerpack weight roughly?
Dave
>>>>>>>>>>>>>>>>>>>>
On Sun, 13 Apr 2003 21:58:07 -0400, <MVTrucker@aol.com> wrote:
> Bob,
> You really should have the manual covering the inner axle seal
> on the front axle. You will also need the special tools for
> removal and installation of the seal. You might have to fabricate the
> tools. I think there's a pic or sketch of the
> remover in the -20P.
> Engine removal is no big deal. The whole power pack can come out as a
> single unit, including the transmission. I alway drain
> and remove the radiator. Although I don't think this is necessary, I know
> I won't damage it having it out of the way.
> Remove the top cover from the transmission so it won't snag
> the firewall while pulling the engine forward.
> Joe Young
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
>
-- Dave
This archive was generated by hypermail 2.1.4 : Wed Apr 23 2003 - 13:30:49 PDT