From: Jim Newton (jnewton@laurel.com)
Date: Sat May 03 2003 - 18:42:32 PDT
Hi List...
Previously I asked:
>Mandatory MV content...what is the total capacity of the master
>cylinder reservoir on a deuce? In other words, if one installed a
>brand new master cylinder, how much DOT 5 would it take to fill the
>master cylinder (ignoring the brake lines)? The value is
>conspicuously left blank in the table on page 4 of LO 9-2320-209-12-1.
Well I changed the brake fluid in my deuce today.
I just wanted to let everyone know that the master cylinder reservoir
on an M35A2 takes about a pint when it is bone dry, not including the
lines, airpack or anything besides the reservoir itself.
I will add a note to the copy of the LO 9-2320-209-12-1 on the
MILDOCS.COM site to reflect this, since the entry in the table on the
original documents is blank.
--Jim "Ike" Newton
o 1984 M1007 CUCV Military Suburban 6.2 Liter (378 CID) Turbo-Diesel Engine 5/4 Ton Cargo Capacity, 4WD
o 1971 M35A2 Military Troop/Cargo Truck "Deuce and a Half" 478 CID Turbo-Diesel Multi-Fuel Engine Air Shift Front Axle 2 1/2 Ton Cargo Capacity, 6WD
See These Trucks at www.CUCV.NET Keyword Searching of 22,000 Electronic TMs at www.MILDOCS.com
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:20:28 PDT