From: IHC53 (IHC53@bellsouth.net)
Date: Fri May 16 2003 - 11:06:28 PDT
I believe it says to cut it with Xylene. Others have mentioned
that they had good results cutting it with mineral spirits, but I
used Xylene.
Worked out OK on my MUTT, and I'll use it on my M1009.
IHC
----- Original Message -----
From: "Mark B. Anderson" <mark@aasurplus.ca>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Friday, May 16, 2003 2:02 PM
Subject: [MV] paint question
> Hi Guys again...
>
> ok got my paint in and gave it to my painter.
> (I'm not a painter at all) He asked me what kind of reducer does it use???
> It is Gillespie Coatings Paint #24087.
>
> Thanks for any help here is there a sheet that shows the different
> reducers??
>
>
>
>
> Mark Anderson
>
> Anderson & Anderson Investigations
> www.mvpa.ca and www.aasurplus.ca
> Prairie Command Member - MVPA Member #25472
> M.C.C. Canada Member #3203
> '56 GMC M-220 - '78 BMW 728 ARMORED
> "Your Full Line Military Surplus Dealer"
> 208 Hwy 16 West
> Box 692
> Neepawa, MB R0J1H0
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:20:30 PDT