From: Rick (lathrrs@snip.net)
Date: Fri May 16 2003 - 11:20:25 PDT
I use a 4 to 1 reduction ratio using Xylene. You can use sythetic enamel
reducer I beleive in a 2:1 ratio as well.
Army Jeep Parts in Bristol, PA has some helpful information on thier website
regarding thinning Gillespie for spraying.
Rick
----- Original Message -----
From: "IHC53" <IHC53@bellsouth.net>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Friday, May 16, 2003 2:06 PM
Subject: Re: [MV] paint question
> I believe it says to cut it with Xylene. Others have mentioned
> that they had good results cutting it with mineral spirits, but I
> used Xylene.
>
> Worked out OK on my MUTT, and I'll use it on my M1009.
>
> IHC
>
>
>
>
>
> ----- Original Message -----
> From: "Mark B. Anderson" <mark@aasurplus.ca>
> To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
> Sent: Friday, May 16, 2003 2:02 PM
> Subject: [MV] paint question
>
>
> > Hi Guys again...
> >
> > ok got my paint in and gave it to my painter.
> > (I'm not a painter at all) He asked me what kind of reducer does it
use???
> > It is Gillespie Coatings Paint #24087.
> >
> > Thanks for any help here is there a sheet that shows the different
> > reducers??
> >
> >
> >
> >
> > Mark Anderson
> >
> > Anderson & Anderson Investigations
> > www.mvpa.ca and www.aasurplus.ca
> > Prairie Command Member - MVPA Member #25472
> > M.C.C. Canada Member #3203
> > '56 GMC M-220 - '78 BMW 728 ARMORED
> > "Your Full Line Military Surplus Dealer"
> > 208 Hwy 16 West
> > Box 692
> > Neepawa, MB R0J1H0
> >
> >
> > ===Mil-Veh is a member-supported mailing list===
> > To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> > To switch to the DIGEST mode, send e-mail to
<mil-veh-digest@mil-veh.org>
> > To reach a human, contact <ack@mil-veh.org>
> >
>
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:20:30 PDT