From: Neil E. Amrhein (neil@compu-powr.com)
Date: Fri Dec 12 2003 - 12:56:59 PST
So, in other words, the water pump should be the *only* piece needed?
----- Original Message -----
From: "Julian Burke" <julian@knology.net>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Friday, December 12, 2003 3:50 PM
Subject: Re: [MV] HMMWV 6.2 to 6.5 swap & parts interchangability?
>
> NO! Everything outside the engine will fit but heads will NOT. Water is
> circulated different in the engine and water pump is different also. Julian
>
>
> List,
> In swapping a 6.5 into a formerly 6.2 powered HMMWV, are there any
> engine parts that are not interchangeable? In other words, if I wanted to
> put a reman 6.5 long block into a 6.2 powered HMMWV, would all of the other
> parts fit properly (manifold, injectors, injector lines, injector pump,
> water pump, exhaust manifolds, etc...)? I think the answer is yes, but I
> want to know for sure.
>
> Thanks,
> Neil
>
> =Mil-Veh is a member-supported mailing list=
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:26:57 PDT