From: noel shelley (noel@shelley1722.freeserve.co.uk)
Date: Sat Feb 07 2004 - 01:44:03 PST
Hi ,
The following may help ! I do not know your vehicle but general
principles are as :-
Loosen the nut on the steering column leaving the nut flush with the top of
the shaft , pour BOILING water over the boss then with a block of wood
against the under side of the boss hit with a hammer . alternatively try to
pull /push off then strike the nut hard .
If this doesn`t work then try a gear puller , you may have to make an
adaptor to fit under the wheel .
Good luck Noel
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:28:32 PDT