From: Buzz (buzz@softcom.net)
Date: Sat Feb 07 2004 - 09:45:42 PST
Get a large beating separator from Hobo Freight:
http://www.harborfreight.com/cpi/ctaf/Displayitem.taf?itemnumber=3979
Then use a 2 jaw puller.
Buzz
On Sat, 7 Feb 2004 09:44:03 -0000, you wrote:
>Hi ,
> The following may help ! I do not know your vehicle but general
>principles are as :-
>Loosen the nut on the steering column leaving the nut flush with the top of
>the shaft , pour BOILING water over the boss then with a block of wood
>against the under side of the boss hit with a hammer . alternatively try to
>pull /push off then strike the nut hard .
>If this doesn`t work then try a gear puller , you may have to make an
>adaptor to fit under the wheel .
>
> Good luck Noel
>
>
>===Mil-Veh is a member-supported mailing list===
>To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
>To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
>To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:28:32 PDT