From: djslager (djslager@icongrp.com)
Date: Sun Feb 15 2004 - 14:54:30 PST
One large cross-over line from bottom of tank will equalize the full in both
tanks.. one gauge,one fuel pump.. hiway trucks are done this way----Doug
Slager ---------------------------------------------------------------------
----------------------------------------------------------------------------
----------------------------------------------------------------------------
-------------------------
----- Original Message -----
From: "Bjorn Brandstedt" <super_deuce@hotmail.com>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Sunday, February 15, 2004 3:52 PM
Subject: Re: [MV] Looking for a few good solenoids!
> Bill, check the Grainger Catalog for solenoid valves of all kinds.
>
> Why not connect the two tanks and just have one working in-tank fuel pump
> and return like the original? No worries about which tank to use... and a
> lot less plumbing etc.
>
> Bjorn
>
>
>
> >From: "Bill & Bonnie Prestin" <bprestin@chartermi.net>
> >To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
> >Subject: [MV] Looking for a few good solenoids!
> >Date: Sun, 15 Feb 2004 15:07:15 -0500
> >
> >
>
> _________________________________________________________________
> Optimize your Internet experience to the max with the new MSN Premium
> Internet Software. http://click.atdmt.com/AVE/go/onm00200359ave/direct/01/
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:28:34 PDT