From: GrimJeeper22@aol.com
Date: Tue Feb 17 2004 - 07:25:28 PST
Amnon,
If your wiring is still in the original configuration, this is how to
install a manual glow plug switch:
Remove the LIGHT BLUE wire from its terminal on the glow plug relay. Run a
new wire from this terminal to your new manual switch, and then to GROUND.
That's all there is to it. When you turn your ignition switch to RUN, you
should have 12V at the PINK/BLACK wire on the relay. When you press your
manual switch, this completes the circuit to ground, and the glow plug relay
should energize. 15-20 seconds should be all you need for a cold engine. You
shouldn't need it at all for a warm engine.
Pretty simple, and it saves a lot of headache with the failure prone original
control system.
Regards,
TCasey
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:28:34 PDT