From: David Cole (DavidCole@tk7.net)
Date: Sat Jun 05 2004 - 21:29:01 PDT
Tom,
Not everyone has a 16" turret lathe in their garage that they can use to
chuck up their spare set of drive flanges (everyone has a set of those
sitting around also??) just to machine out the splines.
I though the design and approach is solid and requires few tools, or at
least not a mill or a lathe.
Dave
On Sat, 5 Jun 2004 13:29:24 -0400, milveh <milveh@carr.org> wrote:
> what a waste of time!! just machine the splines out of a spare set of
> front drive plates. or ask kenny...............
> tom
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
>
-- Dave
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:33:22 PDT