From: VannuffelenC (VannuffelenC@allimand.com)
Date: Thu Jun 24 2004 - 23:51:19 PDT
Mark
-----Message d'origine-----
De : mark baxter [mailto:alleywayguns@bacavalley.com]
Envoyé : jeudi 24 juin 2004 15:17
À : Military Vehicles Mailing List
Objet : [MV] CUCV transmission problem
Listers
IM having troubles with MY M-1009 shifting gears. When I first got the
truck it seemed that the transmission was shifting fine. Then one day I
hopped into it to take it for a ride and it would not shift out either low
or 2nd except after high reving the engine. I took it in to have the tranny
flushed yesterday and that did not help, but it seems like I can manually
shift it and it will run the gears but still acts like it does not want to
move. the other day I leaned up aginst the back of it and it moved forward
about a foot. Could I be looking at tranny problems, or could the rear end
be going out? Thanks for the help!! Mark M-886
Mark,
According my experience on my M1009 in France, I face the same problem 3
years ago.
The problem was caused by the centrifugal regulator wich is driven by a
plastic gear.
This gear loose its teeths,so the regulator don't rotate and no shifting!
I suspect that the wearing of this gear was caused by too high level of oil
in the transmission (this level has to be checked engine running and after
severl miles so the trans oil is hot.
If you fill engine stopped you over fill)
Claude (M1009)
===Mil-Veh is a member-supported mailing list===
To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org> To
reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:33:26 PDT