LD-465-1C Rear Main seal et. al.

From: Kirk Thompson (kpt@lanl.gov)
Date: Tue Jul 27 2004 - 08:30:55 PDT

• Next message: Claude W. Vaughn: "Need 7.50 x 20 tires, near Texas"
• Previous message: Recovry4x4@aol.com: "Re: [MV] Towing an M35A2"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi all.

I need a rear Main seal for a White LD-465-1C engine form a 1970
Kaiser-Jeep M45A2 (M109A3 Shop/Instrumentation Van). As an aside, I have
unsuccessfully used NOS rear outer axle seals in the past and would like to
find a source for a brand-spanking new rear main.

Since I'll have the tranny, flywheel, etc. pulled, what other parts should
I consider replacing?

My list is:
Clutch
Pressure plate
Throwout bearing
Pilot Bushing/bearing

And, can anyone provide me with info on clutches, etc.? My feeling that NOS
clutch, pressure plate, bearing/bushing would be fine but I want to stay
away from 30 year old rubber (ie: seals).

I am going to call Memphis, Antelope Valley, and Sam Winer motors but would
appreciate any responses, advice, horror stories, etc..

Thnx!

-K

• Next message: Claude W. Vaughn: "Need 7.50 x 20 tires, near Texas"
• Previous message: Recovry4x4@aol.com: "Re: [MV] Towing an M35A2"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:33:55 PDT