Re: [MV] stuck front bearing

From: L51940@aol.com
Date: Wed Aug 25 2004 - 17:31:33 PDT

• Next message: Bruce Kalin: "Re: [MV] CHECK OUT THIS R/H DRIVE.!!!"
• Previous message: Bobby Joe Pendleton: "Re: [MV] CHECK OUT THIS R/H DRIVE.!!!"
• Maybe in reply to: Steve & Jeannie Keith: "Re: [MV] stuck front bearing"
• Next in thread: Ida Heath: "Re: [MV] stuck front bearing"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Thanks for all replys; drum is off. Water got in and corroded bearings onto spindle. Made up a piece to go over splined drive shaft end and pulled out outer bearing with drum. Inner bearing was much worse. Had to cut to get out. Does anyone have the Timken bearing number for the inner bearing. It is not legible. Need to get one quick. Leaving for MVPA Great Lakes event in 2 days.

Dave

• Next message: Bruce Kalin: "Re: [MV] CHECK OUT THIS R/H DRIVE.!!!"
• Previous message: Bobby Joe Pendleton: "Re: [MV] CHECK OUT THIS R/H DRIVE.!!!"
• Maybe in reply to: Steve & Jeannie Keith: "Re: [MV] stuck front bearing"
• Next in thread: Ida Heath: "Re: [MV] stuck front bearing"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:34:22 PDT