Re: [MV] M35a2 disk brake parts for front axle needed

From: Sean Nichols (Sean.Nichols@xilinx.com)
Date: Wed Oct 13 2004 - 12:43:02 PDT

• Next message: Joe Garrett: "RE: [MV] M35a2 disk brake parts for front axle needed"
• Previous message: JoeYoungInc@aol.com: "Re: [MV] still need help!"
• Next in thread: Bob Ternes: "Re: [MV] M35a2 disk brake parts for front axle needed"
• Maybe reply: Bob Ternes: "Re: [MV] M35a2 disk brake parts for front axle needed"
• Maybe reply: m35products: "Re: [MV] M35a2 disk brake parts for front axle needed"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi Bob,

Have you tried Boyce Equipment (http://www.boyceequipment.com/)? It
sounds like you are speaking their language here...

Good luck,

Sean Nichols
'42 IHC FFN-3 Crash Truck
'71 AMG M35A2

Bob Ternes wrote:
>
> Anyone got any parts to convert the M35 or M35a2
> axles, made by Timken or Rockwell, to wheel
> disks? Total longshot but maybe these were disks
> by the A3 vintage or something. I have a friend
> looking for a set for a non mil veh application -
> the rears are easy to do with F250 parts but the
> fronts are hard.
>
> Thanks
> Bob Ternes
> 68 -A2
> Boulder, CO
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>

• Next message: Joe Garrett: "RE: [MV] M35a2 disk brake parts for front axle needed"
• Previous message: JoeYoungInc@aol.com: "Re: [MV] still need help!"
• Next in thread: Bob Ternes: "Re: [MV] M35a2 disk brake parts for front axle needed"
• Maybe reply: Bob Ternes: "Re: [MV] M35a2 disk brake parts for front axle needed"
• Maybe reply: m35products: "Re: [MV] M35a2 disk brake parts for front axle needed"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:36:50 PDT