From: Bobby Joe Pendleton (bjpendleton@charter.net)
Date: Sun Oct 17 2004 - 06:51:12 PDT
Carbide should cut it, but I doubt if you can do it with a hand drill
without breaking the carbide drill.
BjP
"Maneo Qualis Manebam"
----- Original Message -----
From: "Dan" <danjan@uniserve.com>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Sunday, 17 October, 2004 00:00
Subject: [MV] drilling armor plate
> Hi listers.
>
> My question today is " is it possible to drill WW2 armor
plate?".
> If so what type of drill bit do I buy?
>
> Thanks
>
> Dan
> ---
> Outgoing mail is certified Virus Free.
> Checked by AVG anti-virus system (http://www.grisoft.com).
> Version: 6.0.775 / Virus Database: 522 - Release Date: 08/10/04
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:36:51 PDT