From: Baker, George R. - Eastman (grbaker@eastman.com)
Date: Tue Oct 26 2004 - 09:31:04 PDT
Guys there's only one way to deal with CARC...sandblast it! Be sure to
use a good respirator and be careful not to over heat the metal, when I
come to a stubborn area I move on then come back to it later after the
metal cools. There's no substitute for a clean, blasted surface.
GRB
, STEVE Hill wrote:
>At the risk of resurrecting the CARC debate, I need to know if the use
of
>paint stripper on CARC poses any additional hazards than it would with
>ordinary paint. I know I don't want to use a sander or grinder on
CARC,
>so it would seem that by using stripper I could get rid of the paint
>without releasing the particles into the air. But, would the fumes be
any
>more dangerous with CARC?
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:36:53 PDT