Re: [MV] Electronic Ign gap Settings 151 Mutt

From: Larry Tighe (larryradio@worldnet.att.net)
Date: Thu Dec 30 2004 - 11:13:05 PST

• Next message: J. Wiehe: "Re: [MV] Electronic Ign gap Settings 151 Mutt"
• Previous message: Stu Ellis: "RE: [MV] Electronic Ign gap Settings 151 Mutt"
• Next in thread: J. Wiehe: "Re: [MV] Electronic Ign gap Settings 151 Mutt"
• Maybe reply: J. Wiehe: "Re: [MV] Electronic Ign gap Settings 151 Mutt"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

TM 9-2320-218-1-1
Page 5-14
Para 5-6 Solid State Ignition Maint. (Cont'd)

c. Adjustment
NOTE:
No adjustment is required for Swiss Controls ignition kit. Adjustment is
required for the Prestolite ignition kit covered in step 10.

Sensor assembly adjustment screw (8)

a) Loosen and adjust air gap between sensor assembly (9) and trigger wheel
contact (7) to .009-.012 inch (.228-.305 mm)

b) Tighten adjusting screw (8) once correct gap is measured.

Lar
www.antiquetelephone.com

• Next message: J. Wiehe: "Re: [MV] Electronic Ign gap Settings 151 Mutt"
• Previous message: Stu Ellis: "RE: [MV] Electronic Ign gap Settings 151 Mutt"
• Next in thread: J. Wiehe: "Re: [MV] Electronic Ign gap Settings 151 Mutt"
• Maybe reply: J. Wiehe: "Re: [MV] Electronic Ign gap Settings 151 Mutt"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:38:56 PDT