From: J. Wiehe (j.wiehe@sympatico.ca)
Date: Thu Dec 30 2004 - 11:22:07 PST
I see where I went wrong now.
I sent a scan of 4-66 & 4-67 from the TM listed below.
I should have kept reading some more.
Jim Wiehe
j.wiehe@sympatico.ca
----- Original Message -----
From: "Larry Tighe" <larryradio@worldnet.att.net>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Thursday, December 30, 2004 2:13 PM
Subject: Re: [MV] Electronic Ign gap Settings 151 Mutt
> TM 9-2320-218-1-1
> Page 5-14
> Para 5-6 Solid State Ignition Maint. (Cont'd)
>
> c. Adjustment
> NOTE:
> No adjustment is required for Swiss Controls ignition kit. Adjustment is
> required for the Prestolite ignition kit covered in step 10.
>
> Sensor assembly adjustment screw (8)
>
> a) Loosen and adjust air gap between sensor assembly (9) and trigger wheel
> contact (7) to .009-.012 inch (.228-.305 mm)
>
> b) Tighten adjusting screw (8) once correct gap is measured.
>
> Lar
> www.antiquetelephone.com
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
>
>
> --
> No virus found in this incoming message.
> Checked by AVG Anti-Virus.
> Version: 7.0.298 / Virus Database: 265.6.6 - Release Date: 28/12/04
>
>
-- No virus found in this outgoing message. Checked by AVG Anti-Virus. Version: 7.0.298 / Virus Database: 265.6.6 - Release Date: 28/12/04
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:38:56 PDT