From: Ryan Gill (rmgill@mindspring.com)
Date: Fri Apr 29 2005 - 07:55:18 PDT
At 8:48 AM -0500 4/29/05, John Stewart-Smith wrote:
>Mark, go to the back of TM 9-2320-361-20.
>There are a bunch of foldout pages.
>Foldout #1 is the entire M35A2 schematic.
>If I was going to make this modification, I would attach wire #16, which is
>input 24V to the left foot dimmer switch, (from headlamp switch pin M) and
>attach it to wire # 491, which goes to both front park lights and comes from
>pin B of the headlamp switch.
>I think its pin B, the schematic is indistinct. The little metal tags on
>each end of the wires are marked so:
>Left foot dimmer switch: 16
>Front park lamp: 491
>Headlamp switch, both headlamps power: 16
>Headlamp switch, park lamp power: 21
>Realize if you connect the two, your headlamps will come on in the Park
>position.
What about a good sized Diode in there to keep the current flowing the one direction?
-- -- ---------------------------------------------------------------- - Data Center Operations Group - - http://web.turner.com/data_center/ - ---------------------------------------------------------------- - Ryan Montieth Gill One CNN Center SE0813 E - - Internet Technologies -- Data Center Operations Manager - - Hours 11am - 7pm Mon - Fri (8Sdc, 10Sdc IT@3Ndc) - - Cellular: 404-545-6205 e-mail: Ryan.Gill@cnn.com - - Office: 404-588-6191 - ---------------------------------------------------------------- - Emergency Power-off != Door release! - ----------------------------------------------------------------
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:42:57 PDT