Re: CUCV High Idle

From: Caleb Pal (m1009@defcon-3.net)
Date: Sat Nov 12 2005 - 12:41:07 PST


Hey Stu,

Sounds like the solidnoid that holds the idle up, which is on the top of the
IP, might be on its way out, or B, the sensor on the rear passnenger side of
the block is on its way out. Its at the very rear of the block, passenger
side, and it clicks off when it reaches a certain temp. Mine usually keeps
it on for 4-6 minutes depending on the temp. One way to see which one is
bad, unhook the green wire going to the solinoid, give 12 volts directly to
the solinoid, and see if it stays on for more than 30-60 seconds. Remember
to push the accelerator to the floor once its enrgized. The sensor can go
bad, had that happen on a m1008, it wouldn't keep the throttle up at all, or
the solinoid can get weak and go tits up.

Good luck.

Caleb



This archive was generated by hypermail 2.1.4 : Tue Jul 18 2006 - 21:31:55 PDT