From: Ryan Gill (rmgill@mindspring.com)
Date: Tue Nov 29 2005 - 08:08:31 PST
At 7:08 AM -0800 11/29/05, Mark W wrote:
>Does anyone have any ideas for building a home made
>compressed air dryer. I need to do some sandblasting
>and I always have problems with moisture from the
>compressor getting to the sandblaster. I did take a
>large coil of copper pipe which is between my
>compressor outlet and the tank and I think this helps,
>but I would like to build something, maybe that water
>cools a heat exchanger. There are expensive
>commericial coolers that use a compressor like an air
>conditioner that dry the air, but I'm looking for
>something affordable.
Put in a drip leg or two as well. I put a gate valve at the bottom of my second one and a ball cock valve at the first one right after the air leaves the tank.
-- -- ---------------------------------------------------------------- - Data Center Operations Group - - http://web.turner.com/data_center/ - ---------------------------------------------------------------- - Ryan Montieth Gill One CNN Center SE0813 E - - Internet Technologies -- Data Center Operations Manager - - Hours 11am - 7pm Mon - Fri (8Sdc, 10Sdc IT@3Ndc) - - Cellular: 404-545-6205 e-mail: Ryan.Gill@cnn.com - - Office: 404-588-6191 - ---------------------------------------------------------------- - Emergency Power-off != Door release! - ----------------------------------------------------------------
This archive was generated by hypermail 2.1.4 : Tue Jul 18 2006 - 21:32:12 PDT