From: Rick v100 (rickv100@yahoo.com)
Date: Tue Nov 29 2005 - 08:31:13 PST
have the air dryer mounted on the wall in a big U at
an angle and have it drain back into the air tank for
the compressor and save installing a ballcock since
moisture will drain back to the tank and be drained
there.
Rick
--- Ryan Gill <rmgill@mindspring.com> wrote:
> At 7:08 AM -0800 11/29/05, Mark W wrote:
> >Does anyone have any ideas for building a home made
> >compressed air dryer. I need to do some
> sandblasting
> >and I always have problems with moisture from the
> >compressor getting to the sandblaster. I did take
> a
> >large coil of copper pipe which is between my
> >compressor outlet and the tank and I think this
> helps,
> >but I would like to build something, maybe that
> water
> >cools a heat exchanger. There are expensive
> >commericial coolers that use a compressor like an
> air
> >conditioner that dry the air, but I'm looking for
> >something affordable.
>
> Put in a drip leg or two as well. I put a gate valve
> at the bottom of my second one and a ball cock valve
> at the first one right after the air leaves the
> tank.
> --
> --
>
----------------------------------------------------------------
> - Data Center Operations Group
> -
> - http://web.turner.com/data_center/
> -
>
----------------------------------------------------------------
> - Ryan Montieth Gill One CNN
> Center SE0813 E -
> - Internet Technologies -- Data Center
> Operations Manager -
> - Hours 11am - 7pm Mon - Fri (8Sdc, 10Sdc
> IT@3Ndc) -
> - Cellular: 404-545-6205 e-mail:
> Ryan.Gill@cnn.com -
> - Office: 404-588-6191
> -
>
----------------------------------------------------------------
> - Emergency Power-off != Door release!
> -
>
----------------------------------------------------------------
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to
> <mil-veh-off@mil-veh.org>
> To reach a human, contact <ackyle@gmail.com>
> Visit the searchable archives at
> http://www.mil-veh.org/archives/
>
This archive was generated by hypermail 2.1.4 : Tue Jul 18 2006 - 21:32:12 PDT