[MV] M38A1 help needed.

• Messages sorted by: [ date ][ thread ][ subject ][ author ]
• Next message: Mark R.: "[MV] Die Cast Replicas"
• Previous message: Jerry Cleveland: "[MV] Museum looking for Sherman Tank"

I have a 1956 M38A1 and I am replacing all seals etc.

To replace the axle seals I have to remove the rear
wheel hubs from the axle shafts. Sofar no luck at all.
It looks as if the wheel hub has been welled to the
axle.
(I have tapered shafts, not the flanged version :-)

Anyone who had the same situation and how did you overcome this
problem.
Any hints & tips are welcome !

Thanks to those in advance who have taken the effort to reply.

-- 
Regards

Henk Stegeman                 Dordrecht

henk@hlnx01.ow.nl             The Netherlands

===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.

• Next message: Mark R.: "[MV] Die Cast Replicas"
• Previous message: Jerry Cleveland: "[MV] Museum looking for Sherman Tank"