Re: [MV] Ring gear and pinion contact pattern questions
Dave Cole (DA_Cole@compuserve.com)
Wed, 21 Jan 1998 08:58:26 -0500
Message text written by "Lee Ethridge"
>$40 might have been reasonable if, as you say, they had pressed all the
bearings and races into the pinion and housing. (Oh, yeah. My wording
was wrong. I meant the differential carrier when I said "housing".)
They pressed three cones. It took about a minute and a half of shop
time.<
Ohh...
That's not exactly cheap, I thought you meant that they pressed the races=
into the axle housing also.
Yep, I'd find a new shim. You could cut one from some shim stock, but
buying one would sure be easier.
Good Luck,
Dave
===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.