[MV] 230 TORNADO ENGINE MOUNTS

MEMASS@aol.com
Sat, 7 Feb 1998 18:42:42 EST

I've finally got my 230 back from the dead. Now its time to shove it back in
my 1967 M715. Trouble is, the rubber engine mounts look horrible. My engine
is not the military version, but a civillian replacement out of an anonymous
jeep. My 230 uses a plate sandwiched between the engine block and timing
cover to support the front of the engine.

Can someone tell me:

1) Which model Jeep(s) had 230s with this sandwiched plate setup?

2) Were all the engine mount bushings (the rubber and metal blocks between the
engine and frame used to isolate engine vibration) the same on all models with
the sandwiched-plate setup?

Reason I'm asking is that its a whole lot easier to say "Do you have any mount
bushings for a 1963 Jeep ...whatever" than dumping a whole lot of parts on the
counter at the auto parts store and saying "Have you ever seen one of these?"

Thanks in advance,

Mark Masse
1967 Kaiser M715 (almost mobile)

===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.