[MV] GPW ENGINE REBORING

OKMTRPOOL@aol.com
Sat, 7 Feb 1998 19:17:03 EST

Messages sorted by: [ date ][ thread ][ subject ][ author ]
Next message: cole@fnet.friendlynet.com: "[MV] N0 44 MB"
Previous message: MEMASS@aol.com: "[MV] 230 TORNADO ENGINE MOUNTS"
Next in thread: D. Garrison: "Re: [MV] GPW ENGINE REBORING"

What is the correct diameter to have the cylinder bored to for (1) a .010
oversize (2) a .020 oversize (3) .030 oversize? What are the actual diameters
of these sizes of oversize pistons? (OK, I know the answer is going to be
simple, but would somebody just post it?)

===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.

Next message: cole@fnet.friendlynet.com: "[MV] N0 44 MB"
Previous message: MEMASS@aol.com: "[MV] 230 TORNADO ENGINE MOUNTS"
Next in thread: D. Garrison: "Re: [MV] GPW ENGINE REBORING"