Re: [MV] Grease method

Andreas Mehlhorn (a.mehlhorn@t-online.de)
Wed, 3 Jun 1998 23:24:24 +0200

Messages sorted by: [ date ][ thread ][ subject ][ author ]
Next message: Joseph_A_Kuti@parsons.com: "Re: [MV] Another M-135/M-211 Question"
Previous message: Wearldunn@aol.com: "[MV] ROPS for M151A2"
Maybe in reply to: King: "[MV] Grease method"
Next in thread: paul vandervort: "Re: [MV] Grease method"

King schrieb:
> I have a question for the guys using the grease method for freeing frozen
> engines.Seeing that most engines the pistons come out the top and you pum=
p
> the grease in thru the top then what do you do after the piston skirt ha=
s
> been driven into the bottom of the block if there is alot of pressure use=
d
> and if it only moved a bit then how do you 'pull' the piston out the top
> when you still have a rust ridge or other crud in the way?

You have to pump, until the piston comes out of the cylinder on the lower
(crankshaft) side. For this reason, and to protect the crankshaft and con-
rods, you have to remove the crankshaft before.

Regards
Andreas

===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.

Next message: Joseph_A_Kuti@parsons.com: "Re: [MV] Another M-135/M-211 Question"
Previous message: Wearldunn@aol.com: "[MV] ROPS for M151A2"
Maybe in reply to: King: "[MV] Grease method"
Next in thread: paul vandervort: "Re: [MV] Grease method"