[MV] M35A2 Transfer Case

Marc A. Dominguez (dingo@shentel.net)
Sat, 14 Nov 1998 04:19:28 -0500

Thanks to everyone who responded, I now have complete #'s for oil and fuel
filters, I'll pass this on in case nobody has the correct #'s for belts,
they are GATES 17465 for the alternator and 17511 for the air compressor.
The transfer case will shift into neutral but will not go futher, the shift
rod is clean with no rust, there is a lot of slop in the shift lever ( two
inches of movement side to side ) and the linkage looks straight and not
bent. I've tried to move steering wheel side to side and moving the truck
foward and reverse as well as double clutching and no luck. I'm going to
pick up the front and rear of the truck with track loaders and try to
unwind the wind up, the transfer case is a spag. If there is a linkage
poblem how do I adjust it ? Thanks to everyone for the assistance.

===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.