>Do Not use a breaker bar with an extension. This can and will shear the
bolts.
>
I've found this only happens with more than 15' of scaffold tube. . . .
. .
>First put some penetrating oil like liquid wrench on the nuts. Use an
impact
>wrench. An impact wrench is like taking a hammer to a breaker bar to
hammer it
>down, but it does it at 1000 hits a minute. This will loosen up some of
the
>rust. If you do not have a impact wrench, or a large enough go to the
local gas
>station with service center.
>
A trick here is to cycle the impact (windy) gun between forwards and
reverse, often trying to do the nuts up a bit before undoing will free
them off.
Richard
(Southampton UK)
===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.