[MV] M-37 carb float level spec

Brent McClearen (brent@multipro.com)
Sun, 16 May 1999 11:53:45 -0500

List,
The carb kit I got for the M37 looks really nice. However there is no
instruction sheet or even an exploded view drawing.
I did down load a carb rebuilding web site from MV Central written by
Alan Bowes. It was quite helpful.
I'm 50% done rebuilding but had other questions. All went well except I
cant get the intake check ball (Item DD on the Exploded view in manual) or
the discharge check ball (item HH) out of their little pockets. I cant get
a rubber tip compressed air nozzle into it to push them out from behind. I
tried picking them out with wire. I left the bowl top cover in carb
cleaning solution for the rest of the night, hoping it would get them loose.
I dont know if the carb will work with these stuck in place.

1. Any ideas on getting these check balls out?
2. Wondered if anyone knew the float level specs and any other specs for
rebuilding this Carter ETW1.

Thanks!!!
Brent brent@multipro.com

===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.