From: Jeff H (jeffrey.hoch@verizon.net)
Date: Wed Jun 11 2003 - 08:29:40 PDT
Hi Eric
I found this on the internet a bit ago, I don't know anything else about
it other than I would like to have it!!
http://www.jd2.com/ The cheaper version uses muscle power which is OK by
me, and you only have to buy the dies that you need.
Jeff H
----- Original Message -----
From: "Eric (Home)" <shadow@vci.net>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Wednesday, June 11, 2003 11:18 AM
Subject: [MV] Pipe bender? Affordable?
>
> I am looking at the possibility of bending my own pipe to make a custom
> front bumper for a CJ2A and was wondering who might make a pipe bender I
> could buy on my TIGHT (squeaks) budget? Model, price, and supplier if
> possible, gracias!
>
> I have no idea what diameter of pipe I need to bend but I figure 1" or so?
> I don't want a HUGE hulking bumper, just something that'll protect my
> Sasgen-Derrick (sw?) pto winch. I have a arc welder so I figured with a
> bender I could fab something up.
>
> Also, when I go around looking for tubing what kinda business do I goto
and
> what is the trade term for that tubing?
>
>
> Eric
>
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:21:43 PDT