From: James Shanks (n1vbn@arrl.net)
Date: Wed Aug 25 2004 - 16:53:21 PDT
I agree with Steve, have you tried manually retracting the brake shoes as
much as possible and then try to remove hub/drum?
Jim
At 06:39 PM 8/25/2004, Steve & Jeannie Keith wrote:
>Are you sure that it is not the brake drum that is
>stuck, and not the bearings? Having the bearings
>stuck is very rare. Very common is the shoes
>having worn down the drum and made a lip on
>the inside that the shoes will now not pass over.
>
>Steve AKA Dr Deuce
>
>
>----- Original Message -----
>From: <L51940@aol.com>
>To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
>Sent: Wednesday, August 25, 2004 6:30 PM
>Subject: [MV] stuck front bearing
>
>
> > I am servicing front brakes on m35a2 and driver front drum won't come off
>due to bearing being stuck on to spindle. Can I use puller pushing off of
>axle shaft? I tried a little heat and have puller hooked up without too
>much pressure on it. Any other ideas?
> >
> > Dave McConnell
> >
> > ===Mil-Veh is a member-supported mailing list===
> > To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> > To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> > To reach a human, contact <ack@mil-veh.org>
> >
>
>
>
>===Mil-Veh is a member-supported mailing list===
>To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
>To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
>To reach a human, contact <ack@mil-veh.org>
James Shanks
n1vbn@arrl.net
1985 M1009
1998 IMZ 8.103
1984 H-D FLHT-C
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:34:22 PDT