From: m35products (m35prod@optonline.net)
Date: Wed Aug 25 2004 - 17:08:04 PDT
There you go, quoting George W. again. apb
----- Original Message -----
From: "Kirk Thompson" <kpt@lanl.gov>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Wednesday, August 25, 2004 6:40 PM
Subject: Re: [MV] stuck front bearing
> "There is no problem that cannot be solved with the proper application of
> high explosives."
>
> ;-)
>
> At 04:31 PM 8/25/2004, L51940@aol.com wrote:
> >I am servicing front brakes on m35a2 and driver front drum won't come off
> >due to bearing being stuck on to spindle. Can I use puller pushing off
of
> >axle shaft? I tried a little heat and have puller hooked up without too
> >much pressure on it. Any other ideas?
> >
> >Dave McConnell
> >
> >===Mil-Veh is a member-supported mailing list===
> >To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> >To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> >To reach a human, contact <ack@mil-veh.org>
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:34:22 PDT