From: Dan Bever (goin_myway@yahoo.com)
Date: Fri Oct 28 2005 - 13:45:18 PDT
Thanks for the info Glenn. Dan Bever
--- G Shaw <milspectruck@verizon.net> wrote:
> Yes the manifolds from a Chrysler or Dodge or
> Plymouth car or truck with the
> 230 cu in engine will work. An exact swap would be
> from a Dodge WM300
> truck.
>
> Glenn
>
> -----Original Message-----
> From: Military Vehicles Mailing List
> [mailto:mil-veh@mil-veh.org] On Behalf
> Of Dan Bever
> Sent: Friday, October 28, 2005 12:27 AM
> To: Military Vehicles Mailing List
> Subject: [MV] M37B1 Motor ?
>
>
> List,
> I just bought a 62 M37B1 last weekend that was
> destined for the scrapper. Actually looks to be
> fairly
> complete and not to bad of shape in my opinion. The
> question I have is regarding the missing exhaust and
> intake manifold and carb setup. The engine is the
> T245
> per the stamping on the left front engine boss.
> Looks
> like the county rescue squad that had it in the past
> converted it over to a 12V setup as it has a civi
> alt., starter, and distributer. Will the
> exhaust/intake manifold from either a car of truck
> work on this engine? At this point my plan is to
> just
> get it up in running and driving condition and worry
> about original stuff later. The engine does turn
> freely so I am going to see if I can get it fired
> up.
> thanks
> Dan Bever
> MVPA 18507
> 1962 M37B1
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to:
> <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to
> <mil-veh-digest@mil-veh.org> To
> reach a human, contact <ack@mil-veh.org>
>
>
> ===Mil-Veh is a member-supported mailing list==To
> unsubscribe, send e-mail to:
> <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to
> <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
>
This archive was generated by hypermail 2.1.4 : Tue Jul 18 2006 - 21:30:56 PDT