From: Arthur Bloom (m35prod@optonline.net)
Date: Mon Mar 06 2006 - 18:55:23 PST
Wire them in series.
apb
----- Original Message -----
| OK... I'm a little of a microgeek. How about something along this line per
From: "Alex" <grossmanalex@qwest.net>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Monday, March 06, 2006 9:24 PM
Subject: Re: [MV] TRAILERS --
| bulb for the mil 24 volt headlights? Any simple 3 terminal device that
will
| handle the 6 amps or so? I hate buying 24volt headlights. :(
| Alex
|
| -----Original Message-----
| From: Military Vehicles Mailing List [mailto:mil-veh@mil-veh.org] On
Behalf
| Of Patrick Jankowiak
| Sent: Friday, March 03, 2006 11:21 PM
| To: Military Vehicles Mailing List
| Subject: Re: [MV] TRAILERS --
|
| One thing could be done, to use a small 24-to-12 switching power supply
| (buck converter) for each lamp to be lit on the trailer. 24V/1A in, 12V/2A
| out.. less any inefficiencies.
|
| truck socket sees proper currents, trailer lamps see proper voltages.
| (unless you have a fat wallet, you should make your own switchers.)
|
| This could also be done cheeply with any solid state circuit that would
| turn the power on and off maybe 100 times a second with a 50% duty cycle.
| Would not need a full blown regulated switcher. (visions of a 555 timer
and
| a BDW94CFP (12A PNP Darlington in an isolated TO-220 case))
|
| but that's for geeks, making your own electronics.
|
| The easiest and cheapest thing by far (other than changing lamps) is to
add
| a second set of lamp fixtures with 24V lamps to include the proper
| connector for your truck's trailer socket. Besides, due to the oddities of
| various brake light wiring schemes among civvy vehicles, you may not want
| to mix and match the wiring.
|
| PJ
|
| Arthur Bloom wrote:
|
| > ----- Original Message -----
| > From: "Ryan Gill" <rmgill@mindspring.com>
| > To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
| > Sent: Friday, March 03, 2006 2:46 PM
| > Subject: Re: [MV] TRAILERS --
| >
| >
| > At 9:58 AM -0700 3/3/06, SGM PANTANO wrote:
| >
| >>Hey...wake up.. There is no such thing as a 24 volt or a 12 volt
trailer..
| >>The light receptacles in the Military tail lights could care less what
| bulb
| >>is in there..
| >
| >
| > But the wiring could. 24 volt wires could be
| > sized smaller, try to run the same wattage bulb
| > at 12 volts and you could fry your wires. Check
| > the wire harness first!
| >
| >
| >
| > Twelve gauge copper wire has an ampacity of 41 in open air (single
| insulated
| > conductor) and an ampacity of 23 in a harness. For 14 gauge wire, the
| > ratings are 32 amps and 17 amps, respectively. It would take a lot of
| lamps
| > to reach those limits. In addition, there are fuses which are designed
to
| > fry before the wires do.
| >
| > Arthur P. Bloom
| >
| >
| > ===Mil-Veh is a member-supported mailing list===
| > To unsubscribe, send e-mail to <mil-veh-off@mil-veh.org>
| > To reach a human, contact <ackyle@gmail.com>
| > Visit the searchable archives at http://www.mil-veh.org/archives/
| >
|
| ===Mil-Veh is a member-supported mailing list===
| To unsubscribe, send e-mail to <mil-veh-off@mil-veh.org>
| To reach a human, contact <ackyle@gmail.com>
| Visit the searchable archives at http://www.mil-veh.org/archives/
|
|
| ===Mil-Veh is a member-supported mailing list===
| To unsubscribe, send e-mail to <mil-veh-off@mil-veh.org>
| To reach a human, contact <ackyle@gmail.com>
| Visit the searchable archives at http://www.mil-veh.org/archives/
|
|
| --
| No virus found in this incoming message.
| Checked by AVG Free Edition.
| Version: 7.1.375 / Virus Database: 268.2.0/275 - Release Date: 3/6/2006
|
|
[ date ]
[ thread ]
[ subject ]
[ author ]
This archive was generated by hypermail 2.1.4 : Tue Jul 18 2006 - 21:41:55 PDT