My MB engine had hardened seats when I went to rebuild it. They are a press fit. Any reputable engine rebuilder should have no trouble installing seats.
Dave Fillman
45 MB
---- you wrote:
> Hi folks,
>
> One last question on this topic from last week.
>
> Has anyone successfully done this and to what extend did it work ?
>
> Was it a repeat performance that had to be revisited a few times (throwing a
> seat) or did the alloy valve seats (for unleaded fuel) bed in the cast iron
> block successfully first time ?
>
> Should they be a press fit, thread fit or welded in ? I have no idea. All
> comments welcome either through Mil-Veh or direct to me.
>
> Many thanks,
>
> John
----------------------------------------------------------------
Get your free email from AltaVista at http://altavista.iname.com
===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.